SGFX Suite · release 0.1.0

Twelve plugins. One shared engine.

Colour EQ and compression, two-band make-up dynamics, convolution reverb, a throw delay that keeps ringing after you let go, tape doubling on its own transports, and the metering to keep it honest. Every one of them inherits the same bypass, oversampling, mid/side, autogain and MIDI-learn — so they all behave the same way.

12VST3 plugins
24saturation models
1–32×oversampling
54IRs in the pack
SGFX Color Comp — colour compressor interface
SGFX_ColorComp — the more gain reduction, the more colour

The suite

Every plugin, every face

Screenshots are the real editors, captured from this build with the project's own snapshot tool — click any one to enlarge it.

SGFX_ColorEQ

EQ · Colour

Two curves with colour in between: EQ1 boosts, one of 24 saturation models colours it, EQ2 cuts what the colour left behind — all on one draggable graph.

1040 × 5724× oversampled8 points / curve

SGFX_ColorComp

Dynamics · Colour

A colorbox compressor: feed-forward compression into a 24-algorithm saturation stage whose drive is pushed by the gain reduction, then a parallel wet/dry mix.

1040 × 572GR graphAuto gain

SGFX_HiLoComp

Dynamics

Two make-up faders against a hard ceiling: LOW LEVEL pushes the quiet parts up, HIGH LEVEL pulls the loud parts down, and a fitted gate decides which one is in charge. Three knobs.

640 × 384Gate4× honest default

SGFX_Depth

Reverb · Space

One dial answers "how far away is this sound?" — Very Close with proximity EQ and transient boost, through Room, Hall and Cave out to Universe. A second dial places it.

532 × 3002 knobsMIDI learn

SGFX_IR

Convolution

An impulse-response loader with a post EQ behind it. Ships with a 54-IR pack of rooms, plates and halls; any wav/aiff/flac you own works as a custom IR.

1040 × 64054 IRs insideDelay-matched dry

SGFX_ThrowDelay

Delay · Modulation

Hold THROW and the effect is fed; let go and the tail rings on, because the delay, chorus, hall and flanger state never stops running. Four characters in one box.

1040 × 7004 modesBPM sync

SGFX_TapeDoubler

Modulation · Width

Two more takes you never recorded. A source path plus two tape voices on their own transports: head position, varispeed and a slow LFO put each one slightly off.

1160 × 564±20 ms heads42.4 ms delay

SGFX_MultibandMonitor

Analysis

Five Linkwitz-Riley bands at 48 dB/oct you can mute one at a time, plus mid/side and mono listening and a DIM that never touches your reference level.

980 × 4205 bands / 4 splitsDIM 0…−12 dB

SGFX_VU

Metering

A VU meter you can calibrate: classic 300 ms ballistics, or RMS, Peak and EBU R128 LUFS. Each instance can be named, and the name travels to the host.

640 × 4304 modesCalibratable

SGFX_Levels

Metering

The numbers, and nothing else: integrated loudness, short-term, dynamic range, peak, true peak and correlation. No parameters, no header, no graph.

640 × 1206 readoutsZero parameters

SGFX_Tuner

Utility

A needle, a note, and which way to turn. Reaches a bass low E at 41.2 Hz and shows nothing else — no reference-pitch knob, no scale, not even a header.

640 × 12041.2 Hz lowPass-through

SGFX_Gain

Utility

Two knobs and a mode switch: stereo L/R or mid/side gain from +24 dB down to silence, with autogain to an RMS target, phase invert and a mono monitor.

640 × 484Mid/side matrixPad-friendly

Under the hood

One base class, one behaviour

Every SGFX effect derives from sgfx::SgfxProcessor. It owns the boring part, so a plugin only implements onProcess() at the effective, possibly oversampled rate.

The common chain

Bypass, oversampling from 1× to 32×, mid/side processing, autogain and an output trim — the same chain, in the same order, in every plugin.

MIDI learn, not just CC slots

Parameters are bound per plugin with the suite's own learn system, and the VST3 wrapper's CC emulation is switched off — 2 048 phantom parameters per instance made insertion crawl in Studio Pro.

Offline twins

Parameters that must not glide in a freeze render get a ".off" twin automatically, so what you hear live is what bounces.

Momentary presses

Mode, link, dim, invert — each toggle also has a momentary "press" parameter, so a pad or a footswitch can drive it without a latch.

Snapshot slots A–D

Four bank slots in the header, plus oversampling and bypass always one click away. State saves parameters, MIDI bindings and the window size you left it at.

One visual language

A single theme header defines the palette (teal for controls, amber for colour, sky for analysis), the Inter font stack and the panel drawing every editor shares.

Inputanalyser + meters
Bypassclick-free
1–32×oversampling
Mid / sidematrix
The pluginonProcess()
Auto gainlevel match
Trimoutput + analyser

Downloads

Take the whole suite, or one plugin

VST3 for Windows 10/11, 64-bit, version 0.1.0. Every archive holds the .vst3 bundle, an install.ps1 and an INSTALL.txt — and SGFX_IR's archive carries its 54 impulse responses with it, so the reverb arrives ready to use.

SGFX Suite — full bundle

All 12 VST3 plugins plus the 54-IR SGFX pack in one archive, built from the same Release build as this page. Run install.ps1 and the plugins go to your VST3 folder while the impulse responses go to the folder SGFX_IR already searches — no runtimes and no installer service, and nothing to configure afterwards.

Full suite · 60.1 MB
PluginWhat it doesFormatSize
SGFX_ColorEQColourDual-graphic flow EQ with 24 colour stagesVST3 · Win x642.3 MBDownload
SGFX_ColorCompColour · DynamicsColour compressor — drive follows the gain reductionVST3 · Win x642.3 MBDownload
SGFX_HiLoCompDynamicsLow/high make-up into a 0 dBFS ceiling, with gateVST3 · Win x642.3 MBDownload
SGFX_GainUtilityStereo or mid/side gain stage with autogainVST3 · Win x642.3 MBDownload
SGFX_DepthReverbOne dial from close to universe, plus placementVST3 · Win x642.3 MBDownload
SGFX_IRConvolutionIR loader with post EQ — 54 IRs includedVST3 · Win x6435.0 MBDownload
SGFX_ThrowDelayDelayThrow-fed delay, chorus, hall and flanger with a live tailVST3 · Win x642.3 MBDownload
SGFX_TapeDoublerModulationSource plus two modulated tape voices on own transportsVST3 · Win x642.3 MBDownload
SGFX_MultibandMonitorAnalysisFive-band crossover monitor with DIM and listening modesVST3 · Win x642.3 MBDownload
SGFX_VUMeteringCalibratable VU / RMS / Peak / LUFS meterVST3 · Win x642.3 MBDownload
SGFX_LevelsMeteringLoudness, true peak and correlation readouts, zero controlsVST3 · Win x642.3 MBDownload
SGFX_TunerUtilityNeedle, note and direction, down to 41.2 HzVST3 · Win x642.3 MBDownload

Install

Unzip, run the script, rescan

Every archive carries install.bat and install.ps1. Double-click the .bat: it puts the plugin bundles in your VST3 folder and, where the archive has one, the impulse responses — then checks that what landed matches what shipped.

Close the DAW

A host that still has the old bundle open will block the copy — that is the one failure worth knowing about.

Double-click install.bat

It runs the PowerShell installer next to it and keeps its window open. Prefer a shell? install.bat -Force, or call install.ps1 directly.

Rescan

Start the DAW and rescan VST3 if it offers that; all twelve show up under the manufacturer SGFX.

Override if you like

-Vst3Dir and -IrPackDir move either destination, -Force replaces what is there, -NoIR leaves the pack alone.

What the script does

:: double-click install.bat, or from a shell: install.bat powershell -ExecutionPolicy Bypass -File .\install.ps1 C:\Program Files\Common Files\VST3\SGFX_Suite\ SGFX_ColorEQ.vst3 SGFX_ColorComp.vst3 SGFX_HiLoComp.vst3 SGFX_Gain.vst3 SGFX_Depth.vst3 SGFX_IR.vst3 SGFX_ThrowDelay.vst3 SGFX_TapeDoubler.vst3 SGFX_MultibandMonitor.vst3 SGFX_VU.vst3 SGFX_Levels.vst3 SGFX_Tuner.vst3 %USERPROFILE%\Documents\SGFX\SGFX_IR_Pack\ <- 54 impulse responses, copied from this same archive

Good to know

The IR pack installs with the plugin. SGFX_IR's own archive and the full suite both contain SGFX_IR_Pack, and the script copies it to %USERPROFILE%\Documents\SGFX\SGFX_IR_Pack. The folders the plugin searches on its own: that one, the shared SGFX folders under ProgramData and Common Documents, your home folder, and an SGFX_IR_Pack sitting next to the host executable. Custom files (wav/aiff/flac/ogg) still work through the Custom source.
VST3 only. None of these has ever been released as VST2 or AU, so there is nothing to enable besides the VST3 scan. Windows x64 only.
Controllers. Plug-ins accept MIDI as control through the suite's own learn, and deliberately do not expose 128 CC parameters each to the host.